Open 7 days, 7am–9pm

Serving Minneapolis, Saint Paul & 50 miles around

Furnace Replacement in Rogers, MN

A new furnace for a Rogers home costs $4,500–$9,500 installed with us, roughly $4,500–$6,000 at 80% AFUE and $6,500–$9,500 at 96–98%. Builder-era furnaces here were often sized by square footage, so we run a Manual J before quoting, and the price stays written and flat-rate.

Request Service

We'll get back to you about this request only. Rather talk now? Call 612-429-3465.

Furnace replacements in Rogers homes

Replacing an original 1990s or 2000s furnace in Rogers usually means swapping one condensing furnace for another, which sounds simple until the venting gets checked. The existing PVC may be 2-inch where the new furnace wants 3-inch for its size and run length, and older terminations may not meet the new manufacturer's instructions. In the two-stories, a variable-speed blower is worth pricing, because it runs long, quiet cycles that help even out the upstairs and main floor.

If the air conditioner is just as old, replacing both together keeps the coil and furnace matched. Out on the former Hassan side, propane furnaces don't qualify for CenterPoint's gas rebates, and electric service may be Wright-Hennepin rather than Xcel Energy, which matters if you add a heat pump. A dual-fuel setup can cut propane use noticeably. A replacement here normally needs a mechanical permit from the city.

Updated November 10, 2026

What affects the price of a new furnace in Rogers?

What moves the quote in Rogers: venting changes on a switch to a condensing furnace, a liner for a water heater left alone in the chimney, and ductwork and returns. See the furnace replacement cost guide.

Are there rebates for a new furnace in Rogers?

Gas furnace rebates in Rogers come from CenterPoint Energy: high-efficiency furnaces, boilers and thermostats, with any dealer you pick. Ask us which rebates apply when we quote. Rebate programs change every year, so check the utility's current terms before you buy.

Our guides: Xcel and CenterPoint rebates, heat pump rebates.

Furnace replacement in Rogers: questions

Our Rogers house already has PVC venting. Can the new furnace reuse it?

Sometimes. Each furnace's installation manual sets the pipe diameter and maximum length for its size, counting every elbow. Builder installs from the 1990s and 2000s often used 2-inch pipe that a new furnace may not allow for the same run, and older terminations may not match current instructions. The old pipe is also glued to the old furnace, so at least the connections get redone. We measure the run before quoting.

Can a new furnace fix the hot upstairs in our Rogers two-story?

Partly. A variable-speed furnace can run its blower at low speed for long stretches, which mixes air between floors and narrows the gap. The bigger fixes are usually on the duct side: adding or enlarging an upstairs return, setting balancing dampers for summer and winter, or zoning the floors. A new furnace sized by Manual J helps too, because an oversized one cycles off before the upstairs catches up.

Contact Us

Heat out? AC quit? Call or send a request.

Send a service request

Prefer to talk it through? Call 612-429-3465.

Call 612-429-3465Request service