Open 7 days, 7am–9pm · $79 trip charge, waived with repair

Now serving Minneapolis, Saint Paul & 50 miles around

Furnace Repair in Spring Lake Park, MN

Most Spring Lake Park homes are 1960s ramblers and split-entries on their second or third furnace, and we repair them 7 days a week, 7am–9pm. The visit is a $79 trip charge, dropped when you approve the repair, and the flat-rate price is written before work begins.

Request Service

Furnace repair in Spring Lake Park: $79 trip charge, waived with the repair.

We'll call or text you back about this request only. Rather talk now? Call 612-429-3465.

Furnace repair calls in Spring Lake Park homes

Furnace trouble in Spring Lake Park often comes from pairing a newer furnace with 1960s ductwork. The trunk-and-branch systems in these ramblers and split-entries were sized around a modest heating blower, and every later addition, such as a denser filter or an AC coil set on top, adds resistance the ducts weren't built for. The blower moves less air, the heat exchanger runs hot, and the limit switch starts cutting the burners mid-cycle.

Split-entry houses add a quirk: the furnace sits in the lower level, and the bedrooms at the far end of the main trunk go cold first. Thermostat wiring is another. Plenty of houses still have the original two-wire cable, and a smart thermostat that powers itself by drawing current through the furnace circuit can make the system cycle oddly or drop out. We check that wiring before we blame a control board.

Updated September 23, 2026

How much does furnace repair cost in Spring Lake Park?

Every furnace repair call in Spring Lake Park starts with a $79 trip charge, waived when you approve the repair, and a written price before any work. Same prices in Spring Lake Park as in every town we serve. National averages (HomeGuide, 2026), not our prices: an inducer motor $400–$1,100, a PSC blower motor $500–$1,400, a variable-speed (ECM) blower motor $800–$2,300. More in the furnace repair cost guide.

Unfinished basement utility area with a washer and dryer, a gas furnace, a water heater and overhead ductwork

Signs your furnace needs a technician

  • The inducer starts, the igniter glows, then the burners never light
  • The burners light for a few seconds and shut off, over and over
  • The furnace runs but the vents blow cool air
  • A blinking code on the control board, or the furnace has locked out
  • Your CO alarm went off or the burner flames look lazy and yellow
  • New banging, squealing or grinding when the furnace starts
  • Water pooling around a high-efficiency furnace

More detail on our furnace repair page.

Symptom guides: Blowing cold air · Won't ignite · Short cycling · Blinking light codes · Pressure switch trips · Strange noises · Leaking water · Burning smell · Red tag · Carbon monoxide

Furnace repair in Spring Lake Park: questions

Why do the bedrooms in our Spring Lake Park split-entry stay cold while the lower level is warm?

In 1960s split-entries, the lower level sits beside the furnace and warms first, while the bedrooms at the end of the main trunk get the least air. Partly closing lower-level registers, checking the branch dampers and replacing a restrictive filter often help. If the blower is weak or static pressure is high, we measure it and give you the repair price in writing before changing anything.

Who do I call about a gas smell versus a furnace that won't heat in Spring Lake Park?

For a gas smell, leave the house and call the gas utility named on your bill from outside. In this part of the north metro that isn't the same company on every street, so keep a bill where you can find it. For a furnace that simply won't heat, call us at 612-429-3465. We're open 7 days, 7am–9pm, and no-heat calls get priority.

Contact Us

Furnace repair in Spring Lake Park? Call or send a request.

Send a service request

We'll call or text you back about this request only. Rather talk now? Call 612-429-3465.

Call 612-429-3465Request service