Why Is My Heat Pump Blowing Cold Air in Winter?
Heat pump air feels cool next to a furnace even while working. Defrost, settings, low charge or failed backup: how to tell, and when to call 612-429-3465.
Read the guide
Heat Pump Installation in Andover, MN
Heat pump installation in Andover costs $7,500–$14,500 on a written flat-rate quote. Connexus Energy supplies the electricity and runs a reduced-rate program for heat pumps paired with a furnace, which makes dual fuel the natural setup.
Heat pump work in Andover homes
Andover's older subdivisions are full of ramblers and split-entries from the 1970s and 80s, and many have already swapped the original furnace for a 96% model vented in PVC. That makes the heat pump an add-on: a coil on the plenum, an outdoor unit, and a controller that decides when the furnace or the heat pump runs. Homes built since the 1990s are larger two-stories and walkouts with condensing furnaces and air exchangers, where the heat pump can replace the AC on its normal schedule.
The biggest payoff is on acreage past the gas mains. Those houses heat with propane, so a heat pump paired with the propane furnace cuts the tank's use. The mechanical room is often crowded with a well tank and softener, so routing takes planning.
Updated October 27, 2026
What affects the price of a heat pump in Andover?
Our $7,500–$14,500 installed price comes as a written flat-rate quote, with a 2-year labor warranty on top of the manufacturer's parts warranty. The price depends on whether a 1970s or 80s rambler already has a 96% PVC-vented furnace to pair with, or a newer two-story swaps its AC. See the heat pump cost guide.
Are there rebates for a heat pump in Andover?
Electricity comes from Connexus Energy, which offers rebates on air-source, ductless and ground-source heat pumps and on central air. Ask whether a Connexus heat pump rebate needs a registered contractor. Rebate programs change every year, so check the utility's current terms before you buy.
Our guides: Xcel and CenterPoint rebates, heat pump rebates.
Heat pumps in Andover: questions
How does a heat pump pair with the propane furnace on an Andover acreage lot?
The heat pump carries most of the heating season and the propane furnace takes over in the deepest cold, and the savings usually beat a gas house because propane tends to cost more. Connexus programs follow your electric service, so propane homes qualify too; ask Connexus whether its current heat pump rebate needs a registered contractor.
Can I keep my 96% furnace and add a heat pump in Andover?
Yes, and it is the common setup. A cold-climate heat pump with a matched coil sits on the furnace plenum, and a control board decides which source runs at each outdoor temperature. Your existing PVC venting stays untouched. We check the plenum size, the electrical panel and the condensate path first, and quote the work in writing.
More in Andover
- Furnace repair in Andover
- Furnace replacement in Andover
- AC repair in Andover
- AC replacement in Andover
- Mini-splits in Andover
- Tune-ups in Andover
- All HVAC service in Andover
Heat pump installs near Andover
- Ham Lake, MN heat pumps · 2 mi
- Anoka, MN heat pumps · 5 mi
- Blaine, MN heat pumps · 6 mi
- Champlin, MN heat pumps · 6 mi
- Oak Grove, MN heat pumps · 8 mi
- Coon Rapids, MN heat pumps · 8 mi
Brands we install and service
Guides on heat pumps
8 Heat Pump Buying Mistakes Minnesota Homeowners Make
Eight heat pump buying mistakes Minnesota homeowners make, from shopping by SEER2 to ground-level outdoor units and outdated rebates, and how to avoid them.
Read the guideHSPF2 and COP: Heat Pump Ratings for Minnesota Winters
HSPF2 is a seasonal average; COP is efficiency at one temperature. For a Minnesota winter, compare capacity and COP at 5°F. Our heat pumps run $7,500–$14,500.
Read the guideContact Us
Heat out? AC quit? Call or send a request.