Open 7 days, 7am–9pm

Serving Minneapolis, Saint Paul & 50 miles around

Furnace Replacement in East Bethel, MN

In East Bethel, a replacement furnace costs $4,500–$9,500 installed with us. An 80% AFUE furnace runs about $4,500–$6,000 and a 96–98% condensing model $6,500–$9,500. Manufactured homes get the same written, flat-rate quote, for a furnace approved for manufactured housing. A Manual J load calculation sets every size.

Request Service

We'll get back to you about this request only. Rather talk now? Call 612-429-3465.

Furnace replacements in East Bethel homes

East Bethel replacements come in three shapes. A manufactured home gets a downflow unit approved for manufactured housing, set on the same floor opening and tied into a matching roof vent. In the 1960s and 70s houses, going from an 80% to a 96% furnace means new PVC through a side wall or roof, and something has to be done about the water heater still venting into the chimney. The newer homes on big lots usually need a like-for-like condensing swap, sized again with a Manual J.

On propane, the furnace gets set up for LP, and a heat pump beside it can carry the milder months on Connexus Energy's lower heating rate. Expect a mechanical permit from the city on a replacement.

Updated November 10, 2026

What affects the price of a new furnace in East Bethel?

What moves the quote in East Bethel: venting changes on a switch to a condensing furnace, a liner for a water heater left alone in the chimney, and ductwork and returns. See the furnace replacement cost guide.

Are there rebates for a new furnace in East Bethel?

Gas rebates follow your gas utility. Ask us which rebates apply when we quote. Rebate programs change every year, so check the utility's current terms before you buy.

Our guides: Xcel and CenterPoint rebates, heat pump rebates.

Furnace replacement in East Bethel: questions

Our East Bethel manufactured home still has its original furnace. What does replacement involve?

A furnace approved for manufactured housing, usually a sealed-combustion downflow model sized to the home, set on the existing floor opening with a new or matched roof vent. Many of these homes also have an AC coil in the same closet, so we check whether it fits the new cabinet. The crossover and floor ducts get inspected too, because a new furnace can't fix heat leaking under the home. The quote is written and flat-rate.

Our Coon Lake Beach lot is small. Where does a new furnace's PVC vent go?

Wherever it meets the manufacturer's clearances: away from windows, doors, the gas meter and regulator, and above the snow line, which on a tight lot can leave only one or two good spots. A roof termination, or a concentric kit that runs both pipes through one opening, often solves it. We also think about where the exhaust plume drifts, since a neighbor's window a few feet away shouldn't take the fog.

Contact Us

Heat out? AC quit? Call or send a request.

Send a service request

Prefer to talk it through? Call 612-429-3465.

Call 612-429-3465Request service