Open 7 days, 7am–9pm

Serving Minneapolis, Saint Paul & 50 miles around

Furnace Replacement in Little Canada, MN

A new furnace for a Little Canada home runs $4,500–$9,500 installed with us, and on the steep Lake Gervais lots we pick the vent exit first. Converted cabins get a room-by-room Manual J in a written, flat-rate quote.

Request Service

We'll get back to you about this request only. Rather talk now? Call 612-429-3465.

Furnace replacements in Little Canada homes

In Little Canada's older single-family houses, the replacement question is mostly venting. A 96–98% furnace moves to PVC through a side wall, and the water heater left in the original chimney needs a liner or a power-vent model. On the steep lots around Lake Gervais and Twin Lake, the vent route has to clear a grade that changes from wall to wall, so we pick the exit before the quote is final.

Converted lake cabins and add-on rooms are where sizing gets tricky. A Manual J counts each room's walls, windows and exposure, and it often shows the old furnace was sized by guesswork. Large lake homes may be better served by zoning or two smaller systems than by one big furnace. Manufactured homes take a furnace listed for manufactured housing, matched to the floor opening and roof vent. Xcel Energy's heating equipment rebates cover high-efficiency gas furnaces. Replacing a furnace in Little Canada normally needs a city mechanical permit.

Updated October 27, 2026

What affects the price of a new furnace in Little Canada?

By efficiency: 80% AFUE roughly $4,500–$6,000; 96–98% AFUE roughly $6,500–$9,500. See the furnace replacement cost guide.

Furnace replacement in Little Canada: questions

Does Xcel's furnace rebate apply to a manufactured home in Little Canada?

It can, if the furnace meets the program's efficiency requirement and your natural gas comes from Xcel Energy, as it does across Little Canada. The choice of furnaces listed for manufactured homes is narrower than for houses, so we check which qualifying models fit your home's duct opening and vent before you decide. Some Xcel measures also need a registered contractor, so confirm the current rules for that model. We supply the model numbers and invoice the application asks for.

We're turning our old lake cabin in Little Canada into a year-round house. When should the new furnace be planned?

Before the walls close. A Manual J on the finished design sets the size, and it decides where supply and return ducts can run, whether the furnace needs a real mechanical room with a vent route, and whether a far wing is better served by a ductless head. Planning it with the builder avoids tearing into new drywall later. If the cabin sits over a crawlspace, insulating and sealing that space belongs in the same plan.

Contact Us

Heat out? AC quit? Call or send a request.

Send a service request

Prefer to talk it through? Call 612-429-3465.

Call 612-429-3465Request service